Tuesday, November 28, 2017

Book Necklaces

I didn't realize it was backwards. Whoops.
Our next foray into wearable art is the book necklace. I made a sample over a month ago, and I very often get comments when I wear it (usually, "where did you get that?"). It isn't hard to make one of your own, but there are several steps involved.  Here's how:

You Will Need:
* One sheet of plain, white paper (printer paper works)
* Card stock or thin cardboard (NOTE: I used white card stock for this project this time, because I had several sheets on hand, but I have done this before with a cereal box; because we are covering the book, it doesn't matter if there is a pattern on the cardboard or not.)
* Colored or patterned paper, for the book cover
* Scissors, tape, glue, ruler
* Necklace string
* Clasps (optional)
* Thumbtack or needle, to make a hole for the string

Not pictured: string, because I forgot it until after I took the photo.
Step One: Folding
Fold the white paper in half from top to bottom, and cut along the fold.
- Take one of the half-sheets and fold it in half, and in half again, and again, and again.  You want 32 small rectangles.


Step Two: Cutting
- Cut out the rectangles; you will need 12 for this project. You can recycle the others, or use them for bookmarks.

Step Three: More Folding and Stapling
- Group the paper into 4 groups of 3 rectangles each.
- Fold each group in half, and staple along the crease. You should have 4 small paper books.

In progress.
Step Four: Taping
- Tape two of the stapled bundles together at the spines; repeat with the other two.
- Tape all four of the little books into one big book.


Step Five: Card Stock
- Set the pages aside and measure out a cover for your book out of card stock.  I found that it worked best if it measured 2.75" x 1.5". When we did this project at the library, I had all the covers pre-cut, so we didn't have to fuss with rulers and pencils and such.
(Why? It needs to be slightly taller than your pages are tall, and a long enough to cover both front and back of the little book, plus room for a spine. Because our little book is roughly 1.25" tall by 1" wide, this seemed to fit well.)

I know you're all jealous of my Woody the Owl ruler, but I'm not selling it.
Step Six: Making a Spine
- Before adding patterned paper, I folded my little book cover around the pages, pressing down to make a nice square spine. This step is optional, but I find that it makes it easier to put together in the end.

Sometimes it helps to see it, not just read it.
Step Seven: Adding Patterned Paper
- Cut a piece of patterned paper that's slightly bigger than your book cover.  I found it easiest to lie my card stock on the wrong side of the patterned paper, then drawing a rectangle around it, making sure to leave 1/4" or so of room for glue.
- Glue the card stock to the blank side of the paper, and then cut off the corners.


Step Eight: More Tape
- Tape down the patterned paper on all four sides, then re-crease the card stock to make it into a book shape again.


- Make a bubble of tape and apply it to the inside of the book cover, on the spine. Press the pages into the tape and hold tightly. You now have an adorable little book!

It's so cute!!
Step Nine: Making a Necklace
- Take a needle or a thumbtack and make a hole toward the top of the spine of your book. Wiggle it around until it's big enough to thread some string through. (Alternately, you can use a jump ring, but I didn't have any of those on hand.)
- Thread a string through the book spine, and cut it to the appropriate length.  Either you can tie your string ends and slip the necklace over your head, or you can add a clasp.


Enjoy!
Miss Kat's Notes:
- Yes, this is held together with mostly tape, but I've had mine for over a month and it hasn't fallen apart yet. I assume you could glue it, but I haven't had the need.
- If you are using cardboard with a pattern on it that you don't want to see, be sure to glue that side of the cardboard to the paper, thus hiding the Trix Rabbit.
- You could get really fancy and print out or draw a tiny copy of your favorite book cover and use that to cover the card stock. I found that I enjoy having a generic book, rather than a specific one, but it's up to you.